Go Back   Weapons Forum > Weapons > General Discussion > Long Guns > Shotguns



Reply
 
LinkBack Thread Tools Display Modes
Old 03-04-2018, 06:58 PM   #1 (permalink)
Junior Member

 
Join Date: Mar 2018
Posts: 15
Default My 590a1

This started out as a model 50774 which was an 18.5" barrel with Choate +1 extension.

I've since done the following mods.

1. Magpul sga stock cerakoted magpul od green with remington 870 synthetic stock adapter and limbsaver airtech pad.

2. Magpul moe Mlok forend cerakoted magpul od green.

3. GG&G Follower

4. S&J hardware +2 extension

5. Soe Gear single point bungee sling od green

6. SOE gear 5 round shotgun card on stock

7. Tacstar side plate with industrial velcro

8. Esstac 7 round shotgun card od green

9. Haley strategic 400 lumen wml light

10. Forcing cone lengthened and polished and barrel back bored by Aimpro Tactical in Conifer Colorado

11. Action job by Aimpro Tactical in Conifer Colorado

12. MCarbo hammer and trigger spring kit (no light strikes).

13. Receiver anodizing blasted and then cerakoted magpul fde

14. Barrel and magazine tube left parkerized and then cerakoted magpul fde

15. S&J extension black nitride blasted which removed the black oxide layer and then it was cerakoted over top of the nitrided metal.

16. Pro mag pm 262 safety

17. Barrel ported by Magnaport

This gun has run flawlessly since it's purchase

It's an 8 shot 18.5" barrel 590a1.

Sent from my SCH-I545 using Tapatalk
tnxdshooter is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On